Mounting Instructions
1. Place the coin on a Soft Cloth.
2. Remove insert from Premier CW Coin Holder and hold it with thumbs on either side of the coin opening.
3. While bending the top of the holder toward you, slide the bottom of the opening against the edge of the coin.
4. When necessary, use your middle fingers to hold the top of the coin in place while you roll the insert down around the top of the coin.
5. If the coin does not easily slip into the grooved slot in the coin opening, you may need to turn the insert over and bend it away from you to get the coin completely into the opening.
6. Remember, never touch the coin's surfaces with your fingers. If you must touch the coin, wear a pair of White Cotton Gloves.
7. If you are adding a Coin World Label it goes into the inset space above the coin on the obverse of the insert.
8. Before placing the insert into the snap-tight coin case, you may want to blow any dust, lint or contaminants out of the case using a Compressed Canned Air Duster.
![]() |
In addition to the chart above Jake's also has a Coin Size Gauge available that takes the guesswork out of determining the diameter and thickness of coins, tokens, medals and medallions. This sensational and easy to use Coin Size Gauge from CoinSafe will measure any coin from 10mm to 50 mm in 0.5 millimeter increments. Great tool for the collector or coin dealer! |
Attention Dealers and Retailers!
We purchase the Coin World Coin Holders in large quantities and offer wholesale pricing.
Be sure to check Jake's Wholesale Page for dealers prices.
For E-mail Coin Orders Orders@Jakesmp.net |
Questions or Comments? Question@Jakesmp.net |
Jake's Newsletter Jake's E-mail News |
Copyright © 2009 Jake's Marketplace, Inc. All rights reserved. Privacy Policy
PRN - SC1100